Material Safety Data Sheet
May be used to comply with
OSHA's Hazard Communication Standard,
29 CFR 1910.1200. Standard must be
consulted for specific requirements.

U.S. Department of Labor
Occupational Safety and Health Administration
(Non-Mandatory Form)
Form Approved
OMB No. 1218-0072
IDENTITY (As Used on Label and List)
SILVERDERM 7
Note: Blank spaces are not permitted. If any item is not applicable, or no information is available, the sace must be marked to indicate that.
Section I
Manufacturer's Name
DermaRite Industries
Emergency Telephone Number
(973) 569-9000
Address (Number, Street, City, State and ZIP code)
3 East 26th Street
Telephone Number for Information
(973) 569-9000
Paterson, New Jersey 07514
Date Prepared
July 15, 2004
 
Signature of preparer (optional)
Section II - Hazardous Ingredients/Identity Information
Hazardous Components (Specific Chemical Identity; Common Name(s))      OSHA PEL      ACGIH  TLV      Other Limits                                                                                                                                                                       Recommended          % (optional)
This product contains the following substances, which are defined as toxic chemicals under, and subject to the
reporting requirements of, Section 313 of Title III of the Superfund Amendments and Reauthorization Act
of 1986 and 40 CFR Part 372:
Silver, CAS No. 7440-22-4 (listed as silver compounds)
 
In addition, these components are considered hazardous chemicals under the criteria of the OSHA Hazard
Communication standard (29 CFR 1910.1200).
Section III - Physical/Chemical Characteristics
Boiling Point
 
Specific Gravity (H2O =1)
 
Vapor Pressure (mm Hg.)
  
Melting Point
 
Vapor Density (AIR =1)
  
Evaporation Rate
(Butyl Acetate =1)
 
Solubility in Water
 
Appearance and Odor
A solid coated fabric. No odor.
Section IV - Fire and Explosion Hazard Data
Flash Ignition Temperature
Nylon - 581 degree Fahrenheit, Method ASTM D1929-77
Silver- Not Applicable
Auto Ignition Temperature
Nylon - 905 degree Fahrenheit
Silver - Not Applicable
Extinguishing Media
Water of other Class A extinguishing agent.
Special Firefighting Procedures
Fire fighters and others who may be exposed to products of combustion should wear full protective clothing including self contained breathing apparatus. Equipment should be thoroughly decontaminated after use.
Unusual Fire and Explosion Hazards
Combustible thermoplastic material and may melt and drip heavy black smoke.
The information and recommendations in this data sheet are believed to be correct and reliable. However the data is offered for consideration and verification by the user and DermaRite Industries L.L.C. offers no guarantee, warrant or representation as to the accuracy or completeness of the data.

MSDS Home